Quick Start Guide
Hardware Connections
Connect the fiber optic cable from your service
provider's network to the PON port.
1
Warning! To avoid possible eye injury, do NOT
look into an operating fiber-optic module's
connector.
Connect a phone.
2
Connect a computer using an Ethernet cable.
3
Connect the power and press the power
4
button.
Point the antennas up.
5
Make sure the LEDs are on and check the
6
PON and PHONE LEDs.
Internet Setup
IP Address: 192.168.1.1
EU Importer: ZyXEL Communication A/S, Generatorvej 8D, 2860 Søborg, Denmark. http://www.zyxel.dk
US Importer: ZyXEL Communications, Inc 1130 North Miller Street Anaheim, CA 92806-2001. http://www.us.zyxel.com
1/2
Wireless N GPON HGU with 4-port GbE Switch
PHONE1
1
6
PON
PON connected and registered.
GREEN
PON
PON not connected. Turn off, disconnect power,
and repeat hardware connection steps.
RED
PON
PON connected but not registered.
ORANGE
2
3
PHONE1
GREEN
PHONE1
RED
PHONE1
OFF
Username: admin
Password: 1234
Copyright © 2016 ZyXEL Communications Corp. All Rights Reserved
PMG5318-B20B
5
4
VoIP registration is complete.
VoIP registration failed.
VoIP setting is not properly configured. Go to
the Web Configurator and configure VoIP
settings.