Printing Takes Too Long; Document Prints From Wrong Tray - Xerox WorkCentre 6605 User Manual

Printing Takes Too Long

Probable Causes
The printer is set to a slower printing mode,
for example, for printing on glossy or
heavyweight paper.
The printer is in Energy Saver mode.
The way the printer was installed on the
network could be an issue.
The job is complex.
The print-quality mode in the driver is set to
Enhanced.
The printer quality is set to Photo and the
printer is being used for complex, 2-sided
print jobs.

Document Prints From Wrong Tray

Probable Causes
Application and print driver have conflicting
tray selections.
Solutions
It takes more time to print on certain types of special paper.
Ensure that the paper type is set properly in the driver and at the
printer control panel. For details, see
Wait. It takes time for printing to start when the printer is coming
out of Energy Saver mode.
Determine if a print spooler or a computer sharing the printer is
buffering all print jobs and then spooling them to the printer.
Spooling can slow print speeds. To test the speed of the printer,
print some information pages such as the Office Demo Page. If
the page does not print at the rated speed of the printer, you
could have a network or printer installation issue.
Wait. No action needed.
Change the print-quality mode in the print driver to Standard.
Increase memory size to 1 GB RAM by installing the Productivity
Kit (Memory).
Solutions
1. Check the tray selected in the print driver.
2. Go to the page setup or printer settings of the application from
which you are printing.
3. Set the paper source to match the tray selected in the print
driver or set the paper source to Automatically Select.
Note: To have the print driver select the tray, set the tray used
as the paper source to Auto Selection Enabled.
WorkCentre 6605 Color Multifunction Printer
Troubleshooting
Print Speed on page 272.
233
User Guide