Adjusting The Transfer Roller; Initializing Nvm - Xerox WorkCentre 6605 User Manual

Maintenance
To adjust the fuser:
1. At the printer control panel, press the Machine Status button.
2. Touch Tools > Admin Settings.
3. Using the keypad, type the passcode as needed.
4. Touch Service Tools.
5. Touch Adjust Fuser.
6. To select the paper type, touch the name of the paper type in the list.
7. To increase or decrease the amount of offset, press the arrow buttons, then press OK.
8. To adjust the fuser for another paper type, select it from the list, then repeat steps 6 and 7.
9. To return to the Service Tools menu, press the Back arrow.

Adjusting the Transfer Roller

Use Adjust Transfer Roller to specify the bias transfer roller voltage for printing on the selected paper
type. If the printed image is too light, increase the offset for the paper you are using. If the printed
image is mottled or blotchy-looking, decrease the offset for the paper you are using.
To adjust the transfer roller:
1. At the printer control panel, press the Machine Status button.
2. Touch Tools > Admin Settings.
3. Using the keypad, type the passcode as needed.
4. Touch Service Tools.
5. Touch Adjust Transfer Roller.
6. To select the paper type, touch the name of the paper type in the list.
7. To increase or decrease the amount of offset, press the arrow buttons, then press OK.
8. To return to the Service Tools menu, press the Back arrow. To return to the Services Home
menu, press the Services Home button.

Initializing NVM

This feature initializes the settings stored in the non-volatile memory (NVM) except for the network
settings. The NVM stores printer settings even after the power is turned off. After executing this
function and restarting the printer, all menu settings are reset to their default values.
To initialize non-volatile memory:
216 WorkCentre 6605 Color Multifunction Printer
User Guide