The Multi-Wan Screen - ZyXEL Communications SBG3300-N series User Manual

Chapter 5 Broadband
Table 15 802.1x: Add/Edit (Sheet 2 of 2)
LABEL
EAP method
Enable
Bidirectional
Authentication
Certificate
Trusted CA
Apply
Cancel

5.7 The multi-WAN Screen

Use the multi-WAN screen to configure the multiple WAN load balance and failover rules to
distribute traffic among different interfaces. This helps to increase overall network throughput and
reliability. Load balancing divides traffic loads between multiple interfaces. This allows you to
improve quality of service and maximize bandwidth utilization for multiple ISP links.
You can only configure one rule for each interface. Click Network Setting > Broadband > multi-
WAN to display the following screen.
Figure 31 Network Setting > Broadband > multi-WAN
The following table describes the labels in this screen.
Table 16 Network Setting > Network Setting > multi-WAN
LABEL
Add New Entry
#
Interface
Mode
Weight
Modify
62
DESCRIPTION
This is the EAP method used for this authentication.
Select this to allow bidirectional authentication.
Select the certificate you want to assign to the authentication. You need to import the
certificate in the Security > Certificates > Local Certificates screen.
Select the Trusted CA you want to assign to the authentication. You need to import the
certificate in the Security > Certificates > Trusted CA screen.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
DESCRIPTION
Click this button to add a previously removed multi-WAN rule entry. By default, adding new
WAN interfaces to the system will generate a corresponding rule entry on this page in active
mode with a weight of 1. Each interface can have only one rule. If the interface you want to
configure already has a rule, you can edit it, or you can delete it before configuring a new
rule.
This is the index number of the entry.
This is the interface that uses the rule.
This shows whether the rule is Active or Passive.
This shows the weight of the rule.
Click the Edit icon to configure the multi-WAN rule.
Click the Delete icon to remove the multi-WAN rule.
SBG3300-N Series User's Guide