Pptp Vpn Setup - ZyXEL Communications SBG3300-N series User Manual

Chapter 20 PPTP VPN

20.3 PPTP VPN Setup

Use this screen to configure settings for a Point to Point Tunneling Protocol (PPTP) server.
Click VPN > PPTP VPN to open the Setup screen as shown next.
Figure 129 VPN > PPTP VPN > Setup
This screen contains the following fields:
Table 100 VPN > PPTP VPN > Setup
LABEL
PPTP Setup
Enable
Local WAN Interface
IP Address Pool
Access Group
(Optional)
Authentication
Method
226
DESCRIPTION
Use this field to turn the Device'S PPTP VPN function on or off.
Select an interface from the drop-down list and its IP address will be shown. This is the
WAN interface upon which PPTP VPN listens to a client's connection request.
Enter the pool of IP addresses that the Device uses to assign to the PPTP VPN clients.
Note: This is with a 24-bit netmask and should not conflict with any configured WAN,
LAN, DMZ, WLAN, or L2TP VPN subnet even if they are not in use.
Specify up to 2 LAN groups (subnets) which a PPTP VPN client is allowed to access. If
none is specified, all LAN groups can be accessed. Enter the IP address and subnet
mask for the LAN group(s).
Select how the Device authenticates a remote user before allowing access to the PPTP
VPN tunnel.
The authentication method has the Device check a user's user name and password
against the Device's local database, which is configured in the Maintenance > User
Account screen.
SBG3300-N Series User's Guide