ZyXEL Communications SBG3300-N series User Manual page 264

Chapter 31 SNMP
• Get - Allows the manager to retrieve an object variable from the agent.
• GetNext - Allows the manager to retrieve the next object variable from a table or list within an
agent. In SNMPv1, when a manager wants to retrieve all elements of a table from an agent, it
initiates a Get operation, followed by a series of GetNext operations.
• Set - Allows the manager to set values for object variables within an agent.
• Trap - Used by the agent to inform the manager of some events.
Click Maintenance > SNMP to open the following screen. Use this screen to configure the Device
SNMP settings.
Figure 147 Maintenance > SNMP
The following table describes the fields in this screen.
Table 119 Maintenance > SNMP
LABEL
SNMP Agent
Get Community
Set Community
System Name
System Location
System Contact
Trap Destination
Apply
Cancel
264
DESCRIPTION
Select Enable to allow a manager station to manage and monitor the Device through
the network via SNMP. Otherwise, select Disable.
Enter the password for the incoming Get and GetNext requests from the management
station. The default is public and allows all requests.
Enter the Set community, which is the password for incoming Set requests from the
management station. The default is public and allows all requests.
Enter the system name of the Device.
Specify the geographic location of the Device.
Enter the name of the person in charge of the Device.
Type the IP address of the station to send your SNMP traps to.
Click Apply to save your changes back to the Device.
Click Cancel to restore your previously saved settings.
SBG3300-N Series User's Guide