The Qos Monitor Screen - ZyXEL Communications SBG3300-N series User Manual

Table 50 Policer Setup: Add/Edit (continued)
LABEL
Non-
Conforming
Action
Available Class
Selected Class
Apply
Cancel

9.7 The QoS Monitor Screen

To view the Device's QoS packet statistics, click Network Setting > QoS > Monitor. The screen
appears as shown.
Figure 74 Network Setting > QoS > Monitor
The following table describes the labels in this screen.
Table 51 Network Setting > QoS > Monitor
LABEL
Refresh Interval
Interface Monitor
#
Name
Pass Rate
Drop Rate
Queue Monitor
#
Name
SBG3300-N Series User's Guide
DESCRIPTION
Specify what the Device does for packets that exceed the excess burst size or peak rate and
burst size (red-marked packets).
• Drop: Discard the packets.
• DSCP Mark: Change the DSCP mark value of the packets. Enter the DSCP mark value to
use. The packets may be dropped if there is congestion on the network.
Select a QoS classifier to apply this QoS policer to traffic that matches the QoS classifier.
Highlight a QoS classifier in the Available Class box and use the > button to move it to the
Selected Class box.
To remove a QoS classifier from the Selected Class box, select it and use the < button.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
DESCRIPTION
Enter how often you want the Device to update this screen. Select No Refresh to stop
refreshing statistics.
This is the index number of the entry.
This shows the name of the interface on the Device.
This shows how many packets forwarded to this interface are transmitted successfully.
This shows how many packets forwarded to this interface are dropped.
This is the index number of the entry.
This shows the name of the queue.
Chapter 9 Quality of Service (QoS)
143