Add/Edit Policy Forwarding; The Rip Screen - ZyXEL Communications SBG3300-N series User Manual

8.3.1 Add/Edit Policy Forwarding

Click Add new Policy Forward Rule in the Policy Forwarding screen or click the Edit icon next
to a policy. Use this screen to configure the required information for a policy route.
Figure 65 Policy Forwarding: Add/Edit
The following table describes the labels in this screen.
Table 42 Policy Forwarding: Add/Edit
LABEL
Policy Name
Source IP
Source Subnet
Mask
Protocol
Source Port
Source MAC
Destination IP
Destination
Subnet Mask
Destination Port
Destination
MAC
WAN
Apply
Cancel

8.4 The RIP Screen

Routing Information Protocol (RIP, RFC 1058 and RFC 1389) allows a device to exchange routing
information with other routers.
SBG3300-N Series User's Guide
DESCRIPTION
Enter a descriptive name of up to 8 printable English keyboard characters, not including
spaces.
Enter the source IP address.
Enter the source subnet mask address.
Select the transport layer protocol (TCP or UDP).
Enter the source port number.
Enter the source MAC address.
Enter the destination IP address.
Enter the destination subnet mask address.
Enter the destination port number.
Enter the destination MAC address.
Select a WAN interface through which the traffic is sent. You must have the WAN
interface(s) already configured in the Broadband screens.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
Chapter 8 Routing
129