Programmable Memory Scan (Pms); Writing Into A Programmable Memory - Yaesu FTM-400DR Operating Manual

5
Press and hold F over 1 second.
Returns to the previous screen.
(2) Individually select memory channels when scanning
1
Switch to Memory mode and then recall the memory
channels to specify as memory channels to skip or
selected memory channels to scan.
2
Press F shortly.
The Function Menu appears.
3
Tap [SKIP/SEL] and set [SKIP] or [SEL].
The scanning method switches between [SKIP] and
[SEL] each time [SKIP/SEL] is tapped.
Reference • The scanning method can also be selected by pressing the O.
4
Press F shortly.
The memory channels to skip/selected memory channels to scan are set and the
screen returns to the previous one.
● Scanning only memory channels selected in the specified memory.
1
Switch to Memory mode and then recall the memory
channels selected for scanning.
2
Tap [SCAN].
Only the memory channels selected in the specified
memory are scanned.
Reference • Pressing and holding [UP] or [DOWN] over 1
second also starts scanning.
• Scanning (SCAN) is performed toward higher
memory channel numbers.
• When a signal is received during scanning, a beep is emitted and scanning pauses for
5 seconds and then it's frequency is recieved.
• To cancle scanning, tap [SCAN] or [PTT] on the microphone.

Programmable Memory Scan (PMS)

Writing into a Programmable Memory

9 sets of PMS memory channels (L1/U1 to L9/U9) are available.
Specify the lower limit frequency of the frequency range you want to san for "L ", and
the upper limit frequency for "U ".
Enter a number between 1 and 9 for " ". Use the same number for the lower and upper
limit.
FCC ID:
IC:
Using the Scanning Function
K6620345X40
511B-20345X40
37