Preparation; Installing The Antenna; Attaching The Belt Clip; Installing The Battery Pack - Yaesu FT3DR Operating Manual

Preparation

Installing the Antenna

1. Turn the antenna clockwise until it is secured.
Do not hold or twist the upper part of the antenna
when installing or removing it. To do so may break the
conductors inside the antenna.
Do not key the transmit without installing the antenna.
The transmitter components may be damaged.

Attaching the Belt Clip

1. Attach the belt clip on the back of transceiver using the
supplied screws (two).
Be sure to use the supplied screws when attaching the belt
clip. If any other screws are used, the belt clip cannot be
secured firmly to the battery pack and the transceiver may
drop off together with the battery pack; the transceiver and
battery pack may fall off, causing injury, breakage and other
damage.

Installing the Battery Pack

1. Insert the bottom tabs of the battery pack in the slots on
the back side lower part of the transceiver.
2. Push the battery in until the battery latches click
securely.
Charge the battery pack before using the transceiver for the
first time after purchase, or when it has not been used for a
long period time.
● Removing the Battery Pack
1. While pressing down the latches, remove the battery
pack.
Press the latches down in the direction of the arrows as
shown in the illustration.
10
Hold the thick base
of the antenna
Battery Latches