Removing The Damaged Print Jet - 3D Systems Cubify CUBEX Duo Replacement Manual

Print jet replacement manual

Hide thumbs Also See for Cubify CUBEX Duo:

Before beginning this process please remove all filament from the print jets

and check that your print pad is level. For instructions on how to do this

please refer to the CubeX users guide

Removing the damaged print jet

1. Turn off the CubeX printer and unplug it from the mains power.

2. Unplug the two white looms from the top of the damaged print jets sensor

board,

3. Label the Print Jet motor looms with the corresponding print jet number and

unplug them.

Table of Contents

Show Quick Links

Do you have a question about the Cubify CUBEX Duo and is the answer not in the manual?

Cubify cubex trio