Msi/Plessey Label Id - Datalogic MAGELLAN 8300 Product Reference Manual

MSI/Plessey Label ID

NOTE
Product Reference Guide
This feature specifies an MSI/Plessey label ID to be added to bar code
data.
The programming feature, Label ID Control, designates whether the Label ID
is transmitted as a prefix or suffix or if Label ID is disabled.
To set this feature:
1. Scan the SWITCH bar code.
2. Scan the bar code,
need to cover any unused bar codes on this and the facing page to
ensure the scanner reads only the bar code you intend to scan.
3. Scan the appropriate digits from the keypad in
resent the desired Label ID characters; entered as two hex pairs. A
table containing the
Hex Values is available in the inside back cover of this manual.
ASCII parameters must be input by scanning a pair of hexadecimal
digits for each character. Thus, to set a two-character value of AB,
bar codes containing the digits '4', '1', '4', and '2' must be scanned.
The selectable range for this option is any hex value from 00 to FF.
4. Complete the programming sequence by scanning the SWITCH
bar code.
SET MSI/PLESSEY LABEL ID
ASCII Character Set
SET MSI/PLESSEY LABEL ID
MSI/Plessey Enable
below. You'll
that rep-
Appendix C
and their corresponding
6-357