128 Supplemental Label Id - Datalogic MAGELLAN 8300 Product Reference Manual

EAN-8 128 Supplemental Label ID
NOTE
Product Reference Guide
This feature specifies an EAN-8 128 Supplemental label ID to be added to
bar code data.
The programming feature, Label ID Control, designates whether the Label ID
is transmitted as a prefix or suffix or if Label ID is disabled.
To set this feature:
1. Scan the SWITCH bar code.
2. Scan the bar code,
below. You'll need to cover any unused bar codes on this and the fac-
ing page to ensure the scanner reads only the bar code you intend to
scan.
3. Scan the appropriate digits from the keypad in
resent the desired Label ID characters; entered as two hex pairs. A
table containing the
Hex Values is available in the inside back cover of this manual.
ASCII parameters must be input by scanning a pair of hexadecimal
digits for each character. Thus, to set a two-character value of AB,
bar codes containing the digits '4', '1', '4', and '2' must be scanned.
The selectable range for this option is any hex value from 00 to FF.
4. Complete the programming sequence by scanning the SWITCH
bar code.
SET EAN-8 128 SUPPLEMENTAL LABEL ID
SET EAN-8 128 SUPPLEMENTAL LABEL ID
ASCII Character Set
EAN-8 Enable
that rep-
Appendix C
and their corresponding
6-213