Number Of Host Transmission Buffers - Datalogic MAGELLAN 8300 Product Reference Manual

Hide thumbs Also See for MAGELLAN 8300:

Table of Contents

Number of Host Transmission Buffers

Specifies the number of host transmission(s) that may be buffered. By

buffering data from a bar code, the scanner can continue to read a new bar

code while the old one is being transmitted to the host. Selecting BUFF-

ERS = 1 means that the first bar code must be transmitted before a new

one can be read. A selection of BUFFERS = 2 means that a new bar code

can be read while data from the first bar code is transmitted. When the

Good Read Beep Control

the data is placed in a transmission buffer.

When a DISABLE SCANNER command is received from the host, the

scanner will continue to transmit all data that is buffered.

To select the Number of Host Transmission Buffers:

1. Scan the SWITCH bar code.

2. Scan bar code below representing the desired setting. You'll need to

cover any unused bar codes on this and the facing page to ensure

that the scanner reads only the bar code you intend to scan.

3. Complete the programming sequence by scanning the SWITCH

NUMBER OF HOST TRANSMISSION BUFFERS = 1

NUMBER OF HOST TRANSMISSION BUFFERS = 2

, is enabled, the scanner will beep when

Show Quick Links

Table of Contents