Number Of Stop Bits - Datalogic MAGELLAN 8300 Product Reference Manual

RS-232 Number of Stop Bits
NOTE
Product Reference Guide
Specifies number of stop bits required for sending and receiving data.
8 data bits with 2 stop bits and parity enabled is not a valid configuration.
To set this feature:
1. Scan the SWITCH bar code.
2. Scan the bar code below representing the desired Stop Bit setting.
You'll need to cover any unused bar codes on this and the facing
page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning the SWITCH
bar code.
RS-232 NUMBER OF STOP BITS = 1
RS-232 NUMBER OF STOP BITS = 2
RS-232 Features
6-109