Ack Nak Retry Count - Datalogic MAGELLAN 8300 Product Reference Manual

RS-232 ACK NAK Retry Count
NOTE
Product Reference Guide
This feature sets the number of times for the scanner to retry a label trans-
mission under a retry condition.
To set the RS-232 ACK NAK Retry Count:
1. Scan the SWITCH bar code.
2. Scan the bar code,
You'll need to cover any unused bar codes on this and the facing
page to ensure that the scanner reads only the bar code you intend
to scan.
3. Scan the appropriate digits from the keypad in
resent the desired number. The selectable range is 0-255 resets. Pad
all single and double digit numbers with leading zeroes to yield a
three-digit entry (000-255).
A setting of 255 specifies "retry forever."
4. The scanner will automatically exit Programming Mode when the
appropriate amount of digits have been scanned.
SET RS-232 ACK NAK RETRY COUNT
SET RS-232 ACK NAK RETRY COUNT
RS-232 Features
below.
that rep-
Appendix C
6-133