Horizontal Scan Window Replacement (Wrg) - Datalogic MAGELLAN 8300 Product Reference Manual

Horizontal Scan Window Replacement (WRG)

NOTE
Product Reference Guide
Wear Resistant Glass (WRG) horizontal scan windows are replaceable and
can be removed and replaced following the instructions below.
Sapphire glass does not require replacement, so it is permanently fastened in
place. Do not attempt to remove Sapphire glass from the platter.
1. Remove the Platter from the scanner as shown in
2. Turn the platter upside down on a clean, dry surface and remove the
two screws shown in
installation.
3. Tilt the Window Retainer up and away from the platter as shown.
4. Lift out the Window Gasket and WRG Window from the Platter as
shown in Figure
5. Position the new WRG Window and its gasket as shown in
Figure 3-6b.
6. Guide the Window Retainer to seat its edge under the tabs and
match the screw holes as shown in
7. Secure the retainer in position using the original two screws.
8. Clean both sides of the new WRG window using a paper towel or
lint free cleaning tissues dampened with a mild, water-based glass
cleaner. DO NOT use abrasive cleaners or pads.
9. Re-install the platter. WRG Window replacement is now complete.
Figure 3-6a. Retain the screws for later re-
3-6b and carefully dispose of any damaged glass.
Figure
Operational Maintenance
Figure 3-4.
3-6a.
3-15