I Programmed Scan/Fine Programmed Scan - Icom IC-7400 Instruction Manual

I Programmed scan/Fine programmed scan (VFO mode)
Programmed scan searches for signals between scan
edge memory channels P1 and P2. The default fre-
quencies for these memories are 0.500000 MHz and
29.99999 MHz, respectively. See p. 65 for scan edges
programming.
q Push [V/M] to select VFO mode, if necessary.
w Select the desired operating mode.
• The operating mode can also be changed while scan-
ning.
e Push [TS] to select a tuning step.
• The tuning step can also be changed while scanning.
r Push [MENU] to select
t Push [F1
] to select the scan menu.
• See p. 68 for scan condition.
• If the [RF/SQL] control function is set as "AUTO," the
squelch is always open in SSB, CW and RTTY modes.
y Push [F1
] to start the programmed scan.
• The MHz and kHz decimal points blink while scanning.
u When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume, VSC
setting and the squelch condition.
i To cancel the scan, push [F1
• Rotating the tuning dial during scan also cancels scan
operation.
If the same frequencies are programmed into the
scan edge memory channel P1 and P2, pro-
grammed scan does not start.
D D About the Fine programmed scan
During programmed scan, when a signal is received,
scan continues, but the tuning step is temporarily set to
10 Hz.
q Follow steps q to y above to start programmed
scan.
w During programmed scan, push [F3
between programmed scan and fine programmed
scan operation.
e Push [F1
] to cancel the scan.
• Rotating the tuning dial during scan also cancels scan
operation.
.
].
] to switch
[MENU]
Mode keys
F 1 F 2 F 3
Push [F1]
∂
F 1 F 2 F 3
Push [F1]
∂
F 1 F 2 F 3
Push [F1] to start/cancel the scanning.
∂
F 1 F 2 F 3
Push [F3] to switch
between programmed
scan and fine pro-
grammed scan.
∂
F 2 F 3
F 1
8
SCANS
[TS] [V/M]
Tuning dial
F 4 F 5
∂
F 4 F 5
F 4 F 5
F 4 F 5
F 4 F 5
70