Icom IC-7400 Instruction Manual page 45

D D Contest number set mode
This menu is used to set the contest (serial) number
and count up trigger, etc.
• Setting contents
q Push [MENU] to select
select the memory keyer menu.
w Push [F4
] to enter the contest number set
mode.
e Push [F1≤] or [F2 ≥] to select the desired set item.
r Set the desired condition using the tuning dial.
• Push [F3] for 1 sec. to select a default condition or value.
t Push [MENU] 2 times to return to
1.
This item sets the numbering system used for contact
(serial) numbers— normal or morse cut numbers.
• : Does not use morse cut number
(default)
• : Sets 1 as A, 9 as N and 0 as O.
• : Sets 1 as A, 9 as N and 0 as T.
• : Sets 9 as N and 0 as O.
• : Sets 9 as N and 0 as T.
2.
This selects which of the four memory slots will have
the contest serial number exchange. The count up
trigger allows the serial number to e automatically in-
cremented after each complete serial number ex-
change is sent.
• M1, M2, M3 and M4 can be set. (default: M2)
3.
This item shows the current number for the count up
trigger channel set above.
• Rotate the tuning dial to change the number, or push
[F3 ] for 1 sec. to reset the current number to 001.
, then push [F4 ] to
.
RECEIVE AND TRANSMIT
F 2 F 3
F 1
Set item up/down
4
F 4 F 5
32