Disabling The Reset Button On Converted Access Points (Cli) - Cisco IOS XE Release 3SE Configuration Manual

Converting Autonomous Access Points to Lightweight Mode
• Authorize MIC APs against AAA
• AP with Manufacturing Installed Certificate
Step 3 Click Apply.
Step 4 Click Save Configuration.

Disabling the Reset Button on Converted Access Points (CLI)

You can enable or disable the Reset button on access points that are converted to lightweight mode. The Reset
button is labeled MODE on the outside of the access point.
The procedure to perform this task using the controller GUI is not currently available.
Note
SUMMARY STEPS
1. enable
2. configure terminal
3. no ap reset-button
4. end
5. ap name Cisco_AP reset-button
DETAILED STEPS
Command or Action
Step 1 enable
Example:
Switch# enable
Step 2 configure terminal
Example:
Switch# configure terminal
Step 3 no ap reset-button
Example:
Switch(config)# no ap reset-button
OL-28697-01
Enters privileged EXEC mode.
Enters global configuration mode.
Disables the Reset buttons on all converted access points that are
associated to the switch.
Note
Lightweight Access Point Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
Disabling the Reset Button on Converted Access Points (CLI)
Purpose
To enable the Reset buttons on all converted access points
that are associated to the switch, enter the ap reset-button
command.
59