Performing A Link Test (Cli) - Cisco IOS XE Release 3SE Configuration Manual

Configuring Link Latency
The Global Configuration page is displayed.
Step 2 In the TCP MSS area, select the Global TCP Adjust MSS check box and set the MSS for all access points that are
associated with the switch. The valid range is from 536 to 1363 bytes.
Step 3
Click Apply.
Step 4 Click Save Configuration.

Performing a Link Test (CLI)

The procedure to perform this task using the switch GUI is not currently available.
Note
SUMMARY STEPS
1. test wireless linktest mac_address
2. configure terminal
3. wireless linktest frame-size frame_size
4. wireless linktest number-of-frames number_of_frames
5. end
DETAILED STEPS
Command or Action
Step 1
test wireless linktest mac_address
Example:
Switch# test wireless linktest
00:0d:88:c5:8a:d1
Step 2 configure terminal
Example:
Switch# configure terminal
Step 3 wireless linktest frame-size frame_size
Example:
Switch(config)# wireless linktest
frame-size 41
Step 4 wireless linktest number-of-frames number_of_frames
Example:
Switch(config)# wireless linktest
number-of-frames 50
OL-28697-01
Lightweight Access Point Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
Performing a Link Test (CLI)
Purpose
Runs a link test.
Enters global configuration mode.
Configures the link test frame size for each packet.
Configures the number of frames to send for the link
test.
87