Authorizing Access Points (Cli) - Cisco IOS XE Release 3SE Configuration Manual

Converting Autonomous Access Points to Lightweight Mode
Note The MODE button on the access point must be
enabled.
Step 7 Hold the MODE button until the status LED turns red (approximately 20 to 30 seconds), and release the MODE button.
Step 8 Wait until the access point reboots as indicated by all LEDs turning green followed by the Status LED blinking green.
Step 9 After the access point reboots, reconfigure the access point using the GUI or the CLI.

Authorizing Access Points (CLI)

SUMMARY STEPS
1. enable
2. configure terminal
3. ap auth-list ap-policy authorize-ap
4. username user_name mac aaa attribute list list_name
5. aaa new-model
6. aaa authorization credential-download auth_list local
7. aaa attribute list list
8. aaa session-id common
9. aaa local authentication default authorization default
10. show ap name Cisco_AP config general
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Switch# enable
Step 2
configure terminal
Example:
Switch# configure terminal
Step 3 ap auth-list ap-policy authorize-ap
Example:
Switch(config)# ap auth-list ap-policy
authorize-ap
OL-28697-01
Lightweight Access Point Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
Authorizing Access Points (CLI)
Purpose
Enters privileged EXEC mode.
Enters global configuration mode.
Configures an access point authorization policy.
57