How To Configure A Static Ip Address On An Access Point; Configuring A Static Ip Address On An Access Point (Cli) - Cisco IOS XE Release 3SE Configuration Manual

Converting Autonomous Access Points to Lightweight Mode

How to Configure a Static IP Address on an Access Point

Configuring a Static IP Address on an Access Point (CLI)

SUMMARY STEPS
1. enable
2. ap name Cisco_AP static-ip ip-address static_ap_address netmask static_ip_netmask gateway
static_ip_gateway
3. enable
4. configure terminal
5. ap static-ip name-server nameserver_ip_address
6. ap static-ip domain static_ip_domain
7. end
8. show ap name Cisco_AP config general
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Switch# enable
Step 2 ap name Cisco_AP static-ip ip-address
static_ap_address netmask static_ip_netmask
gateway static_ip_gateway
Example:
Switch# ap name AP03 static-ip
ip-address
9.9.9.16 netmask 255.255.0.0 gateway
9.9.9.2
OL-28697-01
Purpose
Enters privileged EXEC mode.
Configures a static IP address on the access point. This command
contains the following keywords and arguments:
• ip-address— Specifies the Cisco access point static IP address.
• ip-address— Cisco access point static IP address.
• netmask—Specifies the Cisco access point static IP netmask.
• netmask— Cisco access point static IP netmask.
• gateway—Specifies the Cisco access point gateway.
• gateway— IP address of the Cisco access point gateway.
The access point reboots and rejoins the switch, and the static IP address
that you specify is pushed to the access point. After the static IP address
has been sent to the access point, you can configure the DNS server IP
address and domain name. You must perform Steps 3 and 4 after the
access points reboot.
Lightweight Access Point Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
How to Configure a Static IP Address on an Access Point
61