Configuration Examples For Optimizing Rfid Tracking; Displaying All The Access Points In Monitor Mode: Example - Cisco IOS XE Release 3SE Configuration Manual

Configuration Examples for Optimizing RFID Tracking

DETAILED STEPS
Command or Action
Step 1
ap name Cisco_AP mode monitor submode none
Example:
Switch# ap name 3602a mode monitor
submode none
Step 2 ap name Cisco_AP dot11 24ghz shutdown
Example:
Switch# ap name AP01 dot11 24ghz shutdown
Step 3 ap name Cisco_AP monitor-mode tracking-opt
Example:
Switch# ap name TSIM_AP1 monitor-mode
tracking-opt
Step 4 ap name Cisco_AP monitor-mode dot11b
{fast-channel [first_channel second_channel
third_channel fourth_channel]}
Example:
Switch# ap name AP01 monitor-mode dot11b
fast-channel 1 2 3 4
Step 5 ap name Cisco_AP no dot11 24ghz shutdown
Example:
Switch# ap name AP01 no dot11 24ghz shutdown
Step 6
show ap monitor-mode summary
Example:
Switch# show ap monitor-mode summary
Configuration Examples for Optimizing RFID Tracking

Displaying all the Access Points in Monitor Mode: Example

This example shows how to display all the access points in monitor mode:
Switch# show ap monitor-mode summary
Lightweight Access Point Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
72
Purpose
Specifies the monitor submode for the access point as none.
A warning message indicates that changing the access
Note
point's mode will cause the access point to reboot and
prompts you to specify whether you want to continue
by entering Y.
After you enter Y, the access point reboots.
Disables the access point radio.
Configures the access point to scan only the Dynamic Channel
Assignment (DCA) channels supported by its country of
operation.
To disable tracking optimization for an access point,
Note
enter the ap name Cisco_AP monitor-mode
tracking-opt no-optimization command.
Chooses up to four specific 802.11b channels to be scanned by
the access point.
In the United States, you can assign any value from 1
Note
to 11 (inclusive) to the channel variable. Other countries
support additional channels. You must assign at least
one channel.
Enables the access point radio.
Displays all the access points in monitor mode.
Optimizing RFID Tracking
OL-28697-01