Configuring A Static Ip Address On An Access Point (Gui) - Cisco IOS XE Release 3SE Configuration Manual

Configuring a Static IP Address on an Access Point (GUI)

Command or Action
Step 3
enable
Example:
Switch# enable
Step 4 configure terminal
Example:
Switch# configure terminal
Step 5
ap static-ip name-server
nameserver_ip_address
Example:
Switch(config)# ap static-ip
name-server
10.10.10.205
Step 6 ap static-ip domain static_ip_domain
Example:
Switch(config)# ap static-ip domain
domain1
Step 7
end
Example:
Switch(config)# end
Step 8
show ap name Cisco_AP config general
Example:
Switch# show ap name AP03 config
general
Configuring a Static IP Address on an Access Point (GUI)
Step 1 Choose Configuration > Wireless > Access Points > All APs.
The All APs page is displayed.
Step 2 Click the name of the access point.
The AP > Edit page is displayed.
Step 3
In the General tab, in the IP Config area, select the Static IP check box if you want to assign a static IP address to the
access point.
Step 4 Enter the following details:
• Static IP
Lightweight Access Point Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
62
Converting Autonomous Access Points to Lightweight Mode
Purpose
Enters privileged EXEC mode.
Enters global configuration mode.
Configures a DNS server so that a specific access point or all access
points can discover the switch using DNS resolution.
To undo the DNS server configuration, enter the no ap static-ip
Note
name-server nameserver_ip_address command.
Configures the domain to which a specific access point or all access
points belong.
To undo the domain name configuration, enter the no ap
Note
static-ip domain static_ip_domain command.
Returns to privileged EXEC mode. Alternatively, you can also press
Ctrl-Z to exit global configuration mode.
Displays the IP address configuration for the access point.
OL-28697-01