Cisco IOS XE Release 3SE Configuration Manual page 90

How to Configure Country Codes (CLI)
Command or Action
Step 6
ap country country_code
Example:
Switch(config)# ap country IN
Step 7
end
Example:
Switch(config)# end
Step 8 show wireless country channels
Example:
Switch# show wireless country channels
Step 9
configure terminal
Example:
Switch# configure terminal
Step 10
no ap dot11 5ghz shutdown
Example:
Switch(config)# no ap dot11 5ghz shutdown
Step 11 no ap dot11 24ghz shutdown
Example:
Switch(config)# no ap dot11 24ghz shutdown
Step 12 end
Example:
Switch(config)# end
Step 13 ap name Cisco_AP shutdown
Example:
Switch# ap name AP02 shutdown
Step 14 configure terminal
Example:
Switch# configure terminal
Lightweight Access Point Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
78
Purpose
Assigns access points to a specific country.
Make sure that the country code you choose is
Note
compatible with the regulatory domain of at least one
of the access point's radios.
Returns to privileged EXEC mode. Alternatively, you can also
press Ctrl-Z to exit global configuration mode.
Displays the list of available channels for the country codes
configured on your switch.
Note Perform Steps 9 through 17 only if you have configured
multiple country codes in Step 6.
Enters global configuration mode.
Enables the 802.11a network.
Enables the 802.11b/g network.
Returns to privileged EXEC mode. Alternatively, you can also
press Ctrl-Z to exit global configuration mode.
Disables the access point.
Note Ensure that you disable only the access point for which
you are configuring country codes.
Enters global configuration mode.
Configuring Country Codes
OL-28697-01