How To Configure Wips On Access Points; Configuring Wips On An Access Point (Cli) - Cisco IOS XE Release 3SE Configuration Manual

How to Configure wIPS on Access Points

How to Configure wIPS on Access Points

Configuring wIPS on an Access Point (CLI)

SUMMARY STEPS
1. ap name Cisco_AP mode local
2. ap name Cisco_AP dot11 5ghz shutdown
3. ap name Cisco_AP dot11 24ghz shutdown
4. ap name Cisco_AP mode monitor submode wips
5. ap name Cisco_AP monitor-mode wips-optimized
6. show ap dot11 24ghz monitor
7. ap name Cisco_AP no dot11 5ghz shutdown
8. ap name Cisco_AP no dot11 24ghz shutdown
DETAILED STEPS
Command or Action
Step 1 ap name Cisco_AP mode local
Example:
Switch# ap name AP01 mode local
Step 2 ap name Cisco_AP dot11 5ghz shutdown
Example:
Switch# ap name AP01 dot11 5ghz shutdown
Step 3 ap name Cisco_AP dot11 24ghz shutdown
Example:
Switch# ap name AP02 dot11 24ghz shutdown
Step 4
ap name Cisco_AP mode monitor submode
wips
Example:
Switch# ap name AP01 mode monitor
submode wips
Step 5
ap name Cisco_AP monitor-mode
wips-optimized
Lightweight Access Point Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
38
Configuring Adaptive Wireless Intrusion Prevention System
Purpose
Configures an access point for monitor mode.
A message appears that indicates that changing the AP's mode causes
the access point to reboot. This message also displays a prompt that
enables you to specify whether or not you want to continue with
changing the AP mode. Enter y at the prompt to continue.
Disables the 802.11a radio on the access point.
Disables the 802.11b radio on the access point.
Configures the wIPS submode on the access point.
To disable wIPS on the access point, enter the ap name
Note
Cisco_AP modemonitor submode none command.
Enables wIPS optimized channel scanning for the access point.
OL-28697-01