Configuring Power over Ethernet
•
•
•
•
Finding Feature Information
Information About Configuring Power over Ethernet
When an access point that has been converted to lightweight mode (such as an AP1262) access point is powered
by a power injector that is connected to a Cisco pre-Intelligent Power Management (pre-IPM) switch, you
must configure Power over Ethernet (PoE), which is also known as inline power.
How to Configure Power over Ethernet
Configuring Power over Ethernet (CLI)
SUMMARY STEPS
1. ap name Cisco_AP power injector installed
2. ap name Cisco_AP power injector override
3. ap name Cisco_AP power injector switch-mac-address switch_mac_address
4. show ap name Cisco_AP config general
OL-28697-01
Finding Feature Information, page 91
Information About Configuring Power over Ethernet, page 91
How to Configure Power over Ethernet, page 91
Configuration Examples for Configuring Power over Ethernet, page 93
Lightweight Access Point Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
14
C H A P T E R
91