How To Configure Access Point Retransmission Interval And Retry Count; Configuring The Access Point Retransmission Interval And Retry Count (Cli) - Cisco IOS XE Release 3SE Configuration Manual

How to Configure Access Point Retransmission Interval and Retry Count

to acknowledge the receipt of the request message. Response messages are not explicitly acknowledged;
therefore, if a response message is not received, the original request message is retransmitted after the retransmit
interval. If the request is not acknowledged after a maximum number of retransmissions, the session is closed
and the access points reassociate with another switch.
How to Configure Access Point Retransmission Interval and
Retry Count

Configuring the Access Point Retransmission Interval and Retry Count (CLI)

SUMMARY STEPS
1. enable
2. configure terminal
3. ap capwap retransmit interval interval_time
4. ap capwap retransmit count count_value
5. end
6. ap name Cisco_AP capwap retransmit interval interval_time
7. ap name Cisco_AP capwap retransmit count count_value
8. show ap capwap retransmit
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Switch# enable
Step 2
configure terminal
Example:
Switch# configure terminal
Step 3 ap capwap retransmit interval interval_time
Example:
Switch(config)# ap capwap retransmit interval
2
Step 4 ap capwap retransmit count count_value
Example:
Switch(config)# ap capwap retransmit count
3
Lightweight Access Point Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
32
Configuring Retransmission Interval and Retry Count
Purpose
Enters privileged EXEC mode.
Enters global configuration mode.
Configures the control packet retransmit interval for all access
points globally.
The range for the interval parameter is from 2
Note
to 5.
Configures the control packet retry count for all access points
globally.
The range for the count is from 3
Note
to 8.
OL-28697-01