Cisco IOS XE Release 3SE Configuration Manual page 82

How to Configure Probe Request Forwarding (CLI)
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
Switch# configure terminal
Step 2 wireless probe filter
Example:
Switch(config)# wireless probe
filter
Step 3 wireless probe filter num_probes interval
Example:
Switch(config)# wireless probe
filter 5 5
Step 4
end
Example:
Switch(config)# end
Step 5
show wireless probe
Example:
Switch# show wireless probe
Lightweight Access Point Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
70
Purpose
Enters global configuration mode.
Enables or disables the filtering of probe requests forwarded from an access
point to the switch.
If you enable probe filtering, the default filter setting, the access
Note
point forwards only acknowledged probe requests to the switch. If
you disable probe filtering, the access point forwards both
acknowledged and unacknowledged probe requests to the switch.
Limits the number of probe requests sent to the switch per client per access
point radio in a given interval. You must specify the following arguments
with this command:
• num_probes—Number of probe requests forwarded to the switch per
client per access point radio in a given interval. The range is from 1
to 100.
• interval—Probe limit interval in milliseconds. The range is from 100
to 10000.
Returns to privileged EXEC mode. Alternatively, you can also press Ctrl-Z
to exit global configuration mode.
Displays the advanced probe request configuration.
Configuring Probe Request Forwarding
OL-28697-01