Configuring Static Route For Routing To Another Network - ZyXEL Communications P-660H-61 User Manual

4.9 Configuring Static Route for Routing to Another
Network
In order to extend your Intranet and control traffic flowing directions, you may connect a router to
the ZyXEL Device's LAN. The router may be used to separate two department networks. This
tutorial shows how to configure a static routing rule for two network routings.
In the following figure, router R is connected to the ZyXEL Device's LAN. R connects to two
networks, N1 (192.168.1.x/24) and N2 (192.168.10.x/24). If you want to send traffic from
computer A (in N1 network) to computer B (in N2 network), the traffic is sent to the ZyXEL
Device's WAN default gateway by default. In this case, B will never receive the traffic.
N1
You need to specify a static routing rule on the ZyXEL Device to specify R as the router in charge of
forwarding traffic to N2. In this case, the ZyXEL Device routes traffic from A to R and then R routes
the traffic to B.
N1
ADSL Router Series User's Guide
A
A
R
N2
B
R
N2
B
Chapter 4 Tutorials
63