ZyXEL Communications P-660H-61 User Manual page 129

See Section 8.8.2 on page 139
Figure 45 Network > Wireless LAN > AP: Advanced Setup
The following table describes the labels in this screen.
Table 31 Network > Wireless LAN > AP: Advanced Setup
LABEL
RTS/CTS
Threshold
Fragmentation
Threshold
Output Power
Preamble
802.11 Mode
ADSL Router Series User's Guide
for detailed definitions of the terms listed in this screen.
DESCRIPTION
Enter a value between 0 and 2347.
This is the maximum data fragment size that can be sent. Enter a value between 256 and
2346.
Set the output power of the ZyXEL Device. If there is a high density of APs in an area,
decrease the output power to reduce interference with other APs. Select one of the
following: 100%, 75%, 50% or 25%.
Select a preamble type from the drop-down list menu. Choices are Long or Short. See
the Appendix D on page 331
Select 802.11b Only to allow only IEEE 802.11b compliant WLAN devices to associate
with the ZyXEL Device.
Select 802.11g Only to allow only IEEE 802.11g compliant WLAN devices to associate
with the ZyXEL Device.
Select 802.11b+g to allow either IEEE 802.11b or IEEE 802.11g compliant WLAN
devices to associate with the ZyXEL Device. The transmission rate of your ZyXEL Device
might be reduced.
Select 802.11n to allow only IEEE 802.11n compliant WLAN devices to associate with the
ZyXEL Device.
Select 802.11g+n to allow either IEEE 802.11g or IEEE 802.11n compliant WLAN
devices to associate with the ZyXEL Device. The transmission rate of your ZyXEL Device
might be reduced.
Select 802.11b+g+n to allow IEEE 802.11b, IEEE 802.11g or IEEE802.11n compliant
WLAN devices to associate with the ZyXEL Device. The transmission rate of your ZyXEL
Device might be reduced.
for more information.
Chapter 8 Wireless LAN
129