ZyXEL Communications P-660H-61 User Manual page 89

Configure your wireless settings in this screen. Click Next.
3
Figure 22 Wireless LAN
The following table describes the labels in this screen.
Table 13 Wireless LAN Setup Wizard 2
LABEL
Network
Name(SSID)
Channel
Selection
Security
Back
Next
Exit
Note: The wireless stations and ZyXEL Device must use the same SSID, channel ID and
WEP encryption key (if WEP is enabled), WPA-PSK (if WPA-PSK is enabled) for
wireless communication.
This screen varies depending on the security mode you selected in the previous screen. Fill in the
4
field (if available) and click Next.
ADSL Router Series User's Guide
DESCRIPTION
Enter a descriptive name (up to 32 printable 7-bit ASCII characters) for the wireless
LAN.
If you change this field on the ZyXEL Device, make sure all wireless stations use the
same SSID in order to access the network.
The range of radio frequencies used by IEEE 802.11b/g wireless devices is called a
channel. Select a channel ID that is not already in use by a neighboring device.
Select Manually assign a WPA-PSK key to configure a Pre-Shared Key (WPA-
PSK). Choose this option only if your wireless clients support WPA. See
on page 90 for more information.
Select Manually assign a WEP key to configure a WEP Key. See
page 90 for more information.
Select Disable wireless security to have no wireless LAN security configured and
your network is accessible to any wireless networking device that is within range.
Click this to return to the previous screen without saving.
Click this to continue to the next wizard screen.
Click this to close the wizard screen without saving.
Chapter 5 Internet and Wireless Setup Wizard
Section 5.3.1
Section 5.3.2 on
89