Mac Filter - ZyXEL Communications P-660H-61 User Manual

Chapter 8 Wireless LAN
Table 31 Network > Wireless LAN > AP: Advanced Setup
LABEL
Channel Width
Back
Apply
Cancel

8.2.5 MAC Filter

Use this screen to change your ZyXEL Device's MAC filter settings. Click the Edit button in the AP
screen. The screen appears as shown.
Figure 46 Network > Wireless LAN > AP: MAC Address Filter
130
DESCRIPTION
Select whether the ZyXEL Device uses a wireless channel width of 20MHz or Auto. If
Auto is selected, the ZyXEL Device will use 40MHz if it is supported.
A standard 20MHz channel offers transfer speeds of up to 150Mbps whereas a 40MHz
channel uses two standard channels and offers speeds of up to 300 Mbps.
40MHz (channel bonding or dual channel) bonds two adjacent radio channels to increase
throughput. The wireless clients must also support 40 MHz. It is often better to use the 20
MHz setting in a location where the environment hinders the wireless signal.
Select 20MHz if you want to lessen radio interference with other wireless devices in your
neighborhood or the wireless clients do not support channel bonding.
This field is available only when you set the 802.11 Mode to 802.11n or 802.11b+g+n
in the Advanced Setup screen.
Click this to return to the previous screen without saving.
Click this to save your changes.
Click this to restore your previously saved settings.
ADSL Router Series User's Guide