Installable Long Wave Sfp+ Modules (16Gbit/S); Sfp+ Module Handling Instructions - Fujitsu ETERNUS AF250 S2 Basic Operation Manual

5. Component Expansion/Function Enhancement
Installing Long Wave SFP+ Modules (16Gbit/s)
Short wave SFP+ modules (16Gbit/s) and Long wave SFP+ modules (16Gbit/s) can be mixed in the same host
interface (FC 16Gbit/s).
The SFP+ module configuration must be the same for controller 0 (CM#0) and controller 1 (CM#1).

Installable Long Wave SFP+ Modules (16Gbit/s)

For installable Long wave SFP+ modules (16Gbit/s), refer to "Product List".

SFP+ Module Handling Instructions

●
About Condensation
●
About Static Electricity
●
About Shock
When moving an SFP+ module from a cold place, such as an un-conditioned store
•
house in winter, to a warmer places such as an air-conditioned room, the severe tem-
perature change may result in condensation forming.
To avoid this, allow the packed SFP+ modules sufficient time in the warmer place (one
hour for each 15°C of temperature difference) to adapt to the new temperature.
When handling SFP+ modules, make sure to wear a wrist strap or touch a metal part to
•
discharge the human body's natural static electricity.
Failure to discharge static electricity may cause device failure.
Leave the SFP+ module in its package until ready to install it.
•
Do not handle SFP+ modules roughly or subject them to physical shocks when laying
•
them down.
Do not place any objects on top of SFP+ modules.
•
• Do not knock or drop SFP+ modules on hard objects.
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Operation Guide (Basic)
Copyright 2019 FUJITSU LIMITED
64
P3AG-1842-06ENZ0