Ending Calls; Using A Headset - Polycom SoundPoint IP 32x User Manual

Ending Calls

To end a call:
• Do one of the following:
○ Press the EndCall soft key.
○ Replace the handset.
○ If you're in handsfree speakerphone mode, press the Speakerphone key.
○ If you're in headset mode, press the Headset key. See
Timesaver: Quickly Ending a Call
Your phone may be set up so that you can end calls by tapping the Line Key. If your system
administrator has enabled this feature, you can end an active call by tapping the Line Key
associated with the call.

Using a Headset

If you use a headset, you can set up your phone so that all calls use your headset. You can also use the
hookswitch button on your headset to place, answer, and end calls.
Note: Using an RJ-9 Headset With Your Phone
If your headset has a RJ-9 modular connector, a separate Headset Jack Adapter (P/N 2457-11095-
002) is required if you want to use it with SoundPoint IP 321 and 331 phones. To purchase the
Headset Jack Adapter, contact your reseller.
Plug the headset RJ-9 jack into the adapter, and then plug the adapter into the 2.5mm port on the
right side of the phone as shown below. The headset operates as before.
Troubleshooting: Dealing with Electrostatic Discharge
If headsets are deployed in high static environments where users frequently disconnect and re-
connect the headset to the phone, it is possible that the phone can be damaged by electrostatic
discharge (ESD).
You should take precautions to avoid excessive static buildup in your environment. This can
include humidity control and removal of synthetic materials near the phone location. Antistatic
spray applied to carpets in the workplace can reduce the level of static buildup.
Chapter 2: Using Your Phone
Using a Headset.
17