Cisco TelePresence System Codec C40 Reference Manual page 64

Cisco TelePresence System Codec C40/C60
Contents Introduction
xConfiguration SIP Profile [1..1] Proxy [1..4] Discovery
Select if the SIP Proxy address is to be obtained manually or by using Dynamic Host Configuration
Protocol (DHCP).
Requires user role: ADMIN
Value space: <Auto/Manual>
Auto: When Auto is selected, the SIP Proxy address is obtained using Dynamic Host Configuration
Protocol (DHCP).
Manual: When Manual is selected, the manually configured SIP Proxy address will be used.
Example: xConfiguration SIP Profile 1 Proxy 1 Discovery: Manual
xConfiguration SIP Profile [1..1] Type
Enables SIP extensions and special behaviour for a vendor or provider.
NOTE: The SIP types Alcatel, Avaya, Microsoft, and Nortel are no longer supported from software
version TC6.3.
Requires user role: ADMIN
Value space: <Standard/Cisco>
Standard: Use this when registering to standard SIP Proxy (tested with Cisco TelePresence VCS
and Broadsoft)
Cisco: Use this when registering to Cisco Unified Communication Manager.
Example: xConfiguration SIP Profile 1 Type: Standard
xConfiguration SIP Profile [1..1] Mailbox
When registered to a Cisco Unified Communications Manager (CUCM) you may be offered the
option of having a private voice mailbox. Enter the number (address) of the mailbox in this setting, or
leave the string empty if you do not have a voice mailbox.
Requires user role: ADMIN
Value space: <S: 0, 255>>
Format: String with a maximum of 255 characters.
Example: xConfiguration SIP Profile 1 Mailbox: "12345678"
D14642.15 Codec C40-C60 API Reference Guide TC7.0, JANUARY 2014.
About the API xConfiguration xConfiguration
xConfiguration SIP Profile [1..1] Line
64
xCommand
When registered to a Cisco Unified Communications Manager (CUCM) the endpoint may be part
of a shared line. This means that several devices share the same directory number. The different
devices sharing the same number receive status from the other appearances on the line as defined
in RFC 4235.
Note that shared lines are set up by CUCM, not by the endpoint. Therefore do not change this
setting manually; CUCM pushes this information to the endpoint when required.
Requires user role: ADMIN
Value space: <Private/Shared>
Shared: The system is part of a shared line and is therefore sharing its directory number with other
devices.
Private: This system is not part of a shared line (default).
Example: xConfiguration SIP Profile 1 Line: Private
API Reference Guide
xStatus Appendices
Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.