Cisco TelePresence System Codec C40 Reference Manual page 129

Cisco TelePresence System Codec C40/C60
Contents Introduction
xCommand SystemUnit SoftwareUpgrade
Initiate a software upgrade by fetching the software on a given URL. If the server requires username
and password these parameters must be included.
Requires user role: ADMIN
Parameters:
URL(r): <S: 0, 255>
UserName: <S: 0, 255>
Password: <S: 0, 255>
Example:
xCommand SystemUnit SoftwareUpgrade URL: "ftp://<ftp _ server _ ip _
address>/s52000tc4 _ 0 _ 0.pkg" UserName: testDownload Password: 1234
*r SystemUnitSoftwareUpgradeResult (status=OK):
** end
xCommand SystemUnit ConfigurationProfile Change
Select a previously saved configuration profile. NOTE: Requires a restart of the codec.
Requires user role: ADMIN
Parameters:
Name(r): <S: 0, 255>
Example:
xCommand SystemUnit ConfigurationProfile Change Name: "My _
ConfigurationProfile _ 1"
*r ConfigurationProfileChangeResult (status=OK):
Warning: New configuration profile will be active after next boot.
** end
D14642.15 Codec C40-C60 API Reference Guide TC7.0, JANUARY 2014.
About the API xConfiguration
xCommand SystemUnit ConfigurationProfile Remove
xCommand SystemUnit ConfigurationProfile SaveCurrentConfigurationAs
xCommand SystemUnit ConfigurationProfile List
129
xCommand xCommand
Delete a configuration profile that has been stored in the system.
Requires user role: ADMIN
Parameters:
Name(r): <S: 0, 255>
Example:
xCommand SystemUnit ConfigurationProfile Remove Name: "My _
ConfigurationProfile _ 1"
*r ConfigurationProfileRemoveResult (status=OK):
** end
Save the current system settings into a configuration profile. Assign a name to the new profile. The
name is the unique identifier of the profile.
Requires user role: ADMIN
Parameters:
Name(r): <S: 0, 255>
Example:
xCommand SystemUnit ConfigurationProfile SaveCurrentConfigurationAs Name:
"My _ ConfigurationProfile _ 1"
*r ConfigurationProfileSaveCurrentConfigurationResult (status=OK):
** end
List configuration profiles that has been stored in the system.
Requires user role: ADMIN
Example:
xCommand SystemUnit ConfigurationProfile List
*r ConfigurationProfileListResult (status=OK):
Profile: My _ ConfigurationProfile _ 1
Profile: My _ ConfigurationProfile _ 2
** end
API Reference Guide
xStatus Appendices
Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.