Cisco TelePresence System Codec C40 Reference Manual page 150

Cisco TelePresence System Codec C40/C60
Contents Introduction
xStatus Audio Output LocalOutput [n] Channels
States if the local output channels are mixed into into a mono signal (1) or stereo signal (2).
You can run the command xStatus Audio Output LocalOutput to find the identity [n] of the output.
Value space of the result returned:
<1..2>
Example:
xStatus Audio Output LocalOutput 4 Channels
*s Audio Output LocalOutput 4 Channels: "1"
** end
xStatus Audio Output LocalOutput [n] Connector
Lists the connectors that are attached to the local output.
You can run the command xStatus Audio Output LocalOutput to find the identity [n] of the output.
Value space of the result returned:
<"Line.1"/"Line.2"/"HDMI.1"/"HDMI.2">
Example:
xStatus Audio Output LocalOutput 4 Connector
*s Audio Output LocalOutput 4 Connector: "Line.1"
** end
xStatus Audio Output LocalOutput [n] Input [n] Gain
Shows the gain (dB) on the input, when it is connected to the local output. Range from -54 dB to 15
dB, where -54 dB equals Off.
You can run the command xStatus Audio Output LocalOutput to find the identity [n] of the output
and input.
Value space of the result returned:
<-54..15>
Example:
xStatus Audio Output LocalOutput 4 Input 2 Gain
*s Audio Output LocalOutput 4 Input 2 Gain: 0
** end
D14642.15 Codec C40-C60 API Reference Guide TC7.0, JANUARY 2014.
About the API xConfiguration
xStatus Audio Output RemoteOutput [n] CallId
xStatus Audio Output RemoteOutput [n] Input [n] Gain
xStatus Audio Module [0] Type
150
xCommand
Shows the CallId for the remote audio output.
You can run the command xStatus Audio Output RemoteOutput to find the identity [n] of the output.
Value space of the result returned:
<1..65534>
Example:
xStatus Audio Output RemoteOutput 9 CallId
*s Audio Output RemoteOutput 9 CallId: 28
** end
Shows the gain (dB) on the input, when input is connected to the remote output. Range from -54 dB
to 15 dB, where -54 dB equals Off.
You can run the command xStatus Audio Output RemoteOutput to find the identity [n] of the output
and input.
Value space of the result returned:
<-54..15>
Example:
xStatus Audio Output RemoteOutput 9 Input 1 Gain
*s Audio Output RemoteOutput 9 Input 1 Gain: 0
** end
Shows the audio module type. If the module type is DigitalNAM (Digital Natural Audio Module) you
can also read the SoftwareId and HardwareId.
Value space of the result returned:
<DigitalNAM/Unknown>
Example:
xStatus Audio Module 0 Type
*s Audio Module 0 Type: DigitalNAM
** end
API Reference Guide
xStatus xStatus Appendices
Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.