Shear Adjustment; To Adjust The Hold Down Finger - AMF Reece S-101 Installation Manual

THEORY AND ADJUSTMENT TO INSURE PROPER FUNCTIONING OF CORD
The excess end of the cord after the trimming must be pulled back with enough cord left in the throat
plate to insure the proper start of another buttonhole - weight
the drop of this cord. Pull back is adjusted by loosening screw
(Spring in Figure 2, acts
taken off the race by pressing inward the plunger
adjustment is made - cord can not be drawn backward.

SHEAR ADJUSTMENT

Do not sharpen blades from the top or flats.
Stone the edges only at (X) and (XX).

TO ADJUST THE HOLD DOWN FINGER

Revised 09/2004
e-mail: service@amfreece.cz; parts@amfreece.cz ; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
CORD TRIM - MACHINE ADJUSTMENT
, has a clamp and a tension on cord) . To adjust - the yoke
For tension upon
the blades,
loosen nut
and screw down
on screw
This machine is supplied with a hold down finger
work while cutting of thread takes place and regular clamp arms are
up. Adjust by loosening nut
clearance and easy insertion of work.
on cord pull back serves to do this
and adjusting stop
and adjusting with screw
.
Note:
This finger has been supplied with an
adjustable screw
nut turn screw
with nut after obtaining desired
pressure of finger on work.
and adjust screw
S-101
To adjust for tension -
adjust spring with
screw until there is
sufficient friction on
cord to lift weight
upward to contact
throat plate
to suit.
is
. When proper
- to adjust loosen
to suit and lock
for holding the
for proper
1-27