To Adjust The Rocker Arm And Stop Motion - AMF Reece S-101 Installation Manual

S-101
MACHINE ADJUSTMENTS - CORRECTIVE AND MAINTENANCE

TO ADJUST THE ROCKER ARM AND STOP MOTION

Crank the machine with L.H. handwheel, to its stopping position. With the R.H. handwheel
(knurled rim) turn until dog
should have a very light contact on low point of cam
loosening screw (Figure 3a) and swing rocking lever
sheet.
Note:
Also that roller is at the
peak of gauge .
When the parts are in the
position shown there must be
a clearance of about 1/32" at
- if not - adjust by
loosening nut and raise or
lower lever to suit.
Note:
Before tightening screw
be sure parts and
bear against sides of the
boss on head casting.
1-18
is in contact with the stop bolt
both
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146+ (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
- when in this position roller
on handwheel. Make adjustment by
to suit. See note at bottom left of
With the L.H. handwheel, crank the machine until the
rocking lever is as far back as it will go. (at this
point the dog and the stop bolt
apart at (Figure 2a).
Important:
Before making these adjustments
be sure that the adjustments on
sheet 16 (Pressure on length
gauge) are correct.
are about 1/8"
Revised 09/2004