To Adjust Play In Split Collar Yoke; To Line Up And Adjust The Cutting Lever - AMF Reece S-101 Installation Manual

MACHINE ADJUSTMENTS - CORRECTIVE AND MAINTENANCE
TO ADJUST PLAY IN SPLIT COLLAR
YOKE
This yoke must be adjusted to work smoothly
but without excessibe play. Part
loosen screw and screw up nut

TO LINE UP AND ADJUST THE CUTTING LEVER

To adjust cutting messure, turn nuts
inward for more pressure or outward
for less.
Important!
Release cutting pressure completely
before installing a new cutting steel.
When indentation of knife in cutting steel has become too deep,
the face should be filed until the impressions barely seen. Follow
up by adjusting the cutting pressure to cut.
When replacing with new block. Level the cutting surface
with a file until impression of cutter is distinct throughout its
length. (on both cut after and cut before machines).
Cutter may be aligned as to center and position of eye.
Loosen screw and adjust knife forward or backward for
correct eye position
For centering adjust cutter in either direction with screws
for additional adjustment loosen three screws
block in the direction desired.
Revised 09/2004
e-mail: service@amfreece.cz; parts@amfreece.cz ; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
is a nut -
to suit.
The cutting lever is suspended upon two
adjustable studs
centralization of cutting lever.
and move
. Adjust these studs for
- Cutting after -
same instructions apply to cut
before machines using this
cutting arrangement.
,
S-101
3 screws
1-15