Model 101 - Setting Up Instructions - AMF Reece S-101 Installation Manual

S-101
Before operating the machine by hand or power, remove the two shipping pins
are easily identified by a red tag tied to each - these pins
Head and Bed Plate
Set up machine in accordance with the instructions on the installation template that is sent with
each new machine. This template shows two different installations depending on direction of
rotation of the power shaft. The one marked „Preferred Installation" on which the left hand
machine belt is crossed and the
right hand one open, should
always be employed when the
machine is installed on a Reece
Individual Motorized Table. The
„Preferred Installation" should also
be used whenever possible in cases
where the machine is installed on a
line shaft table.
In the event that the machine
should be disassembled at any
time, the correct line-up of the
Head on the Bed Plate
re-established by using one of the
shipping pins in the follower
manner:
Turn the left hand crank handle until
shipping pin hole
Head corresponds with shipping
pin hole in Bed Plate
and do not line up exactly,
loosen clamp screw
move the Head of machine to left
or right until holes
when tested with the shipping pin.
If no shipping pin is available,
proceed as outlined above, but match
line on Head with line
Bed Plate as illustrated Fig. 2.
Important - Before tightening clamp
screw , press lever 1-C19
upward on the stud to lightly contact
the shoulder of the Cam Case
Note - Do not follow these line-up
instructions on Adjustable Fly Bar
machines. Use the instructions on
Sheet 28.
1-4

MODEL 101 - SETTING UP INSTRUCTIONS

together as a protection against shipping damages.
can be
Fig. 2 in the
. If holes
Fig. 2 and
and line up
on
.
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146+ (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
are installed at the factory to lock the
shown Fig.1, which
Revised 09/2004