To Adjust L.h. Handwheel To Disengage At The Stopping Position Of The Machine; To Adjust For Friction On Worm Shaft - AMF Reece S-101 Installation Manual

S-101
MACHINE ADJUSTMENTS - CORRECTIVE AND MAINTENANCE
TO ADJUST L.H. HANDWHEEL TO DISENGAGE AT THE STOPPING POSITION OF
THE MACHINE
In this position contact points
have a clearance about 1/64" - if not: loosen
nut and move stud
as required to obtain this clearance.
Important:
R.H. stop wheel (knurled rim) must be
locked when making this adjustment

TO ADJUST FOR FRICTION ON WORM SHAFT

Loosen screw on collar
that there is a compression of the spring
washer - amount of compression
determines the amount of friction.
Do not set this collar too tightly.
TO ADJUST FOR FRICTION ON MAIN CAM
Loosen nut .
Adjust screw inward for more friction
and outward for less.
Do not place too much friction against the
cam.
1-20
and should
in slot forward or back
. Set collar so
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146+ (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
Revised 09/2004