Threading Diagrams - AMF Reece S-101 Installation Manual

UPPER SYSTEM
Thread is
Detail
between
tension discs
Long groove
THREADING OF FIXED TYPE TENSIONS
S p l i t d i s c t y p e
To needle bar
THREADING OF ROCKING TYPE TENSIONS
S p l i t d i s c t y p e
To needle bar
N o t e : Refer to sheet 23 for additional information on threading Cord Trim Machines.
Revised 09/2004
e-mail: service@amfreece.cz; parts@amfreece.cz ; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606

THREADING DIAGRAMS

Use T-20 thrading wire for
threading needle bar
To needle bar
From thread
supply
N o t e : Thread makes approximately one full turn
around the roller on this tension.
From thread
supply
Spread washer so that
thread will rest in notch
S o l i d r o l l e r t y p e
S o l i d r o l l e r t y p e
To needle bar
N o t e : Thread makes approximately 1 1/2 turns
around the roller on this tension.
S-101
Detail
From thread
supply
From thread
supply
1-5