Upper Thread Draw-Off And Tension Adjustments; Thread Pick-Up Adjustments; Under Thread Draw-Off And Tension Release - AMF Reece S-101 Installation Manual

UPPER THREAD DRAW OFF AND TENSION ADJUSTMENTS
Keep tension tight enough to bread the upper thread at the last stitch.
Make sure that lever
will be effective during the sewing cycle. This tension should swing in the direction of arrow
(Y) when the machine reaches the far end of its travel and in the direction of arrow (X) just
before the machine stops.
To obtain maximum length of starting thread at
Make sure machine is in its normal stopping position. Loosen screws
to the point where pin
tighten screws and
To decrease the length of starting thread
at , adjust the position of cam
required in the direction of arrow marked
less, Figure 1.
Note:
For machines equipped with needle bar
type upper thread draw off, see sheet
22.
UNDER THREAD DRAW-OFF AND
TENSION RELEASE
To provide more of less thread, loosen
nut and adjust stud
suit.
Tighten nut securely.
Revised 09/2004
e-mail: service@amfreece.cz; parts@amfreece.cz ; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
CORD TRIM - MACHINE ADJUSTMENT
releases tension
is at the bottom of the cam drop at
securely.
as
THREAD PICK-UP ADJUSTMENT
The pick-up hook
and grasps the upper thread and holds it out of the way for
the next buttonhole. - The extent of the dip downward so
that it will not miss the thread
the screw
pin
up or down to
when the machine starts sewing, so that only tension
proceed as follows:
Figure 2 dips with the cutting lever
and swinging the plate
as desired.
and and rotate cam
as shown Figure 1. Then
is adjusted by loosening
upon its fulcrum
S-101
1-25