Adjusting The Stop Latch On Stitching Wheel; Adjusting The Trigger Setting Mechanism; To Adjust The Timing Of The L.h. Handwheel In Relation To Rocker Shaft And Lever - AMF Reece S-101 Installation Manual

MACHINE ADJUSTMENTS - CORRECTIVE AND MAINTENANCE

ADJUSTING THE STOP LATCH ON STITCHING WHEEL

Note:
Factory adjustment of this eccentric is
made so that thick side of eccentric
is toward rear. This position must be
maintained to prevent screw
backing out.
ADJUSTING THE TRIGGER SETTING
MECHANISM
TO ADJUST THE TIMING OF THE L.H. HANDWHEEL IN RELATION TO ROCKER
SHAFT AND LEVER
Crank the machine back until stop bolt contact points
contact points and
If not - loosen screw
set screw securely.
Revised 09/2004
e-mail: service@amfreece.cz; parts@amfreece.cz ; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
from
on L.H. handwheel should just clear as shown in detail (Figure 5)
in spool and move wheel
Loosen screw
which will adjust latch
ledge
until there is a clearance of dog
as in Figure 2 between cam and
wheel at
Adjustment should be make when
R.H. stitch wheel is locked.
When the machine is at the stopping position
bumper should be adjusted against pin
that the pin will fall freely into notch and
engage part - this sets the machine for
stitching.
barely disengages
in or out to obtain this clearance. Reset the
. Turn eccentric
against
- adjust to raise or lower
and cam in pulley at
- as in Figure 4 -
S-101
.
so
1-19