Cut Before - Machine Adjustments - AMF Reece S-101 Installation Manual

Important:
Before making the adjustments shown on this sheet, be sure the right hand stitch wheel is
locked.
VERTICAL SETTING OF TRIMMING KNIFE
The trimming knife
the under side of throat plate
spreader stop at
(Figure 1) and move trimming knife
Tighten screw securely.
TRIMMING KNIFE STOP POSITION
Extent of movement at the point of trimming - see Figure 3.
The cutting edge of the trimming knife
advanced sufficiently beyond the shoulder of the R.H.
looper to assure full engagement and constant trimming of
the front leg of the thread loop - To check this adjustment
proceed as follows:
When actuator has risen to its full height the knife should
be ar niminum in an advanced position to the right to clear
the slot in the throat plate at
further to the right, loosen check nut
screw sufficiently upward to gain the maximum of
movement, but being sure that some clearance is always
maintained under head of
If for any reason it is desired to remove trimming mechanism to facilitate looper adjustment - Remove
spring and raise slightly spring clip
Revised 09/2004
e-mail: service@amfreece.cz; parts@amfreece.cz ; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606

CUT BEFORE - MACHINE ADJUSTMENTS

(Figure 1) should be set so it will clear
at and top of right hand
to obtain this setting. Loosen screw
up or down to suit.
TRIMMING KNIFE ACTUATOR ADJUSTMENT
When acutator
depressed the end of trimmer holder
of the trimming knife
of the right hand looper
To obtain this setting, loopes lock nut
actuator
securely.
- to advance the knife
and turn adjusting
at .
(Figure 3) and slide unit off the stud
(Figure 2) has of its own action fully
up or down to suit. Tighten lock nut
should be
the extreme point
should be in line with the point
.
and adjust
.
S-101
1-21