Table of Contents
Advertisement
(11) Setting the registration conditions
REGISTER NO.
The previously specified register number is
displayed. To change the register number, press
the SET key. While the number is highlighted,
press the up and down arrow keys to change it.
Next, adjust the image you want to measure.
1. Press the SEL key to move the cursor to the
"F" position in the upper function menu. Press
the up and down arrow keys to change the
"F" to "T." Now the image from "CAM1" will be
displayed as a through image on the monitor.
Note: When the image is difficult to see,
change the image setting between
"BRT" and "DRK." After changing from
the "Freeze" to the "Through" image
display, press the left key once and
then press the up key once. The "Dark"
image setting can be selected.
2. Adjust the focus and aperture of the camera
lens to obtain a clear image of the object.
See pages 5-3.
3. After the measurement object image is clearly
visible, change the image mode back to "F"
(Freeze) using the up and down arrow keys.
By switching the image display mode from "T" to "F," the image will be captured by the IV-
C35M controller.
Note: Whenever you want to register a reference image, the image display mode should be
changed to "F."
4. Press the SEL key and move the cursor from the upper function menu to the "REG COND"
screen.
Setting Examples Using the Set Wizard
REG COND
SCREEN COND SAVE
1REGISTER NO
0 (0 7)
2MEAS SHAPE
RECTANGLE
3MEAS AREA
SET (224, 208) (287, 271)
4CELL SIZE
16 (4 96)
=VALUE INPUT ESC=BACK SEL=CHNG IMG TRG=FUNC
REG COND
SCREEN COND SAVE
1REGISTER NO
2MEAS SHAPE
3MEAS AREA
4CELL SIZE
=VALUE INPUT ESC=BACK SEL=CHNG IMG TRG=FUNC
7-17
RED F C1 BRT
RED F C1 BRT
0 (0 7)
RECTANGLE
SET (224, 208) (287, 271)
16 (4 96)
7
Advertisement
Table of Contents
