Table of Contents
Advertisement
= In this example, the settings on the STEP8 (DST&AGL COND SET) to STEP8 (MAIN OPS
MENU) are not changed. Select "NEXT" on each of these screens to go to the next screen. =
STEP8
USE SETTING DESTANCE
ANGLE CONDITIONS (YES/NO)
1
NO
2
YES
RETURN NEXT
Settings for distance and angle
conditions.
- For details, see Chapter 18 in
Function and Operation.
ADD MEASUREMENT CONDITIONS?
1NO
2YES
RETURN NEXT
Settings for measurement conditions.
- For details, see Chapter 3 in
Function and Operation.
STEP8
SELECT AN INTERFACE FOR
OUTPUTTING RESULTS WHEN THE
INPUT IS THE PARALLEL I/F
1NO
2COMPUTER LINK
3SERIAL I/F
RETURN NEXT
Settings of interface to output results.
- For details, see Chapter 22 and 23
in Function and Operation.
Setting Examples Using the Set Wizard
STEP8
COMPARE MEASUREMENT
SETTINGS TO MEASUREMENT
RESULTS (YES/NO)
1NO
2YES(MEAS)
3YES(DST&AGL)
RETURN NEXT
Settings for measurement results.
- For details, see Chapter 19 in
Function and Operation.
STEP8
CALCULATE SETTINGS FOR ALL
MEASUREMENT RESULTS(YES/NO)
1NO
2YES(MEAS)
RETURN NEXT
Settings for the calculations applied
to all measurements.
- For details, see Chapter 19 in
Function and Operation.
STEP8
CHANGE DISPLY CONTENTS OF
THE MAIN OPS MENU
1NO
2YES
RETURN NEXT
Settings for displaying the operation
screen.
- For details, see page 6-14.
7-31
STEP8
LADDER CIRCUIT AND RESULT
OUTPUT BASED ON MEASUREMENT
AND CALCULATION RESULT (YES/NO)
1NO
2YES(MEAS)
3YES(DST&AGL)
RETURN NEXT
Output settings.
- For details, see Chapter 22 in
Function and Operation.
STEP8
SET LADDER CIRCUIT RESULT
OUTPUT BASED ON ALL
MEASUREMENT AND CALCULATION
RESULTS (YES/NO)
1NO
2YES
RETURN NEXT
Settings for the calculations applied
to all measurements.
- For details, see Chapter 19 in
Function and Operation.
7
Advertisement
Table of Contents
